MMU 2.6.30-rc7 initramfs - master branch

SDRAM :
                Icache:OK
                Dcache:OK
        U-Boot Start:0x9ffc0000
FLASH: 32 MB
MAC:00:E0:0C:00:00:FD
eth0: Xilinx XPS LocalLink Tri-Mode Ether MAC #0 at 0x81C00000.
Unsupported mode
U-Boot-mONStR> run a
TFTP from server 192.168.0.102; our IP address is 192.168.0.3
Filename 'image.ub'.
Load address: 0x90800000
Loading: Unsupported mode
T 100BASE-T/FD
#################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         #################################################################
         ####################################
done
Bytes transferred = 7197252 (6dd244 hex)
TFTP from server 192.168.0.102; our IP address is 192.168.0.3
Filename 'system.dtb'.
Load address: 0x92000000
Loading: 100BASE-T/FD
#
done
Bytes transferred = 9101 (238d hex)
## Booting kernel from Legacy Image at 90800000 ...
   Image Name:   kernel bez FS
   Image Type:   MicroBlaze Linux Kernel Image (uncompressed)
   Data Size:    7197188 Bytes =  6.9 MB
   Load Address: 90000000
   Entry Point:  90000000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK
OK
## Flattened Device Tree blob at 92000000
   Booting using the fdt blob at 0x92000000
## Transferring control to Linux (at address 90000000), 0x00000000 ramdisk 0x00000000, FDT 0x92000000...
early_printk_console is enabled at 0x84000000
Ramdisk addr 0x00000003, FDT 0x92000000
Found FDT at 0x92000000
Linux version 2.6.30-rc7-00641-g98c67b3 (monstr@monstr.eu) (gcc version 4.1.2) #74 Fri May 29 10:57:24 CEST 2009
setup_cpuinfo: initialising
setup_cpuinfo: Using full CPU PVR support
setup_memory: max_mapnr: 0x10000
setup_memory: min_low_pfn: 0x90000
setup_memory: max_low_pfn: 0xa0000
On node 0 totalpages: 65536
free_area_init_node: node 0, pgdat c02d84c8, node_mem_map c070e000
  Normal zone: 512 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 65024 pages, LIFO batch:15
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 65024
Kernel command line: console=ttyUL0,115200 highres=on
NR_IRQS:32
xlnx,xps-intc-1.00.a #0 at 0xfdfff000, num_irq=9, edge=0x100
PID hash table entries: 1024 (order: 10, 4096 bytes)
xlnx,xps-timer-1.00.a #0 at 0xfdffe000, irq=3
Heartbeat GPIO at 0xfdffd000
microblaze_timer_set_mode: shutdown
microblaze_timer_set_mode: periodic
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 252160k/262144k available
Calibrating delay loop... 61.03 BogoMIPS (lpj=305152)
Mount-cache hash table entries: 512
net_namespace: 564 bytes
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
XGpio: /plb@0/gpio@81400000: registered
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 5, 163840 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
NET: Registered protocol family 1
audit: initializing netlink socket (disabled)
type=2000 audit(5.060:1): initialized
msgmni has been set to 492
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
84000000.serial: ttyUL0 at MMIO 0x84000003 (irq = 8) is a uartlite
console [ttyUL0] enabled
brd: module loaded
Device Tree Probing 'ethernet'
xilinx_lltemac 81c00000.ethernet: MAC address is now  2: 0: 0: 0: 0: 0
xilinx_lltemac 81c00000.ethernet: XLlTemac: using DMA mode.
XLlTemac: Dma base address: phy: 0x84600180, virt: 0xd001c180
XLlTemac: buffer descriptor size: 32768 (0x8000)
XLlTemac: Allocating DMA descriptors with kmalloc<6>XLlTemac: (buffer_descriptor_init) phy: 0x9f370000, virt: 0xcf370000, size: 0x8000
XTemac: PHY detected at address 7.
eth0 (): not using net_device_ops yet
eth0: Dropping NETIF_F_SG since no checksum feature.
xilinx_lltemac 81c00000.ethernet: eth0: Xilinx TEMAC at 0x81C00000 mapped to 0xD0016000, irq=5
TCP cubic registered
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
Freeing unused kernel memory: 4100k freed
Mounting proc: 
Mounting var: 
Populating /var: 
Running local start scripts.
Mounting sysfs:
Setting hostname: 
Setting up interface lo: 
Setting up interface eth0: 
Starting httpd: 
Mounting nfs server

uclinux login: root
Password: 
login[31]: root login on 'ttyUL0'
# ls
# ps
  PID USER       VSZ STAT COMMAND
    1 root      2476 S    init  
    2 root         0 SW<  [kthreadd]
    3 root         0 SW<  [ksoftirqd/0]
    4 root         0 SW<  [watchdog/0]
    5 root         0 SW<  [events/0]
    6 root         0 SW<  [khelper]
    7 root         0 SW<  [async/mgr]
    8 root         0 SW<  [kblockd/0]
    9 root         0 SW   [khungtaskd]
   10 root         0 SW   [pdflush]
   11 root         0 SW   [pdflush]
   12 root         0 SW<  [kswapd0]
   13 root         0 SW<  [aio/0]
   14 root         0 SW<  [nfsiod]
   15 root         0 SW<  [cifsoplockd]
   16 root         0 SW<  [rpciod/0]
   31 root      2480 S    -sh 
   33 root      2480 R    ps 
# ping 192.168.0.1
PING 192.168.0.1 (192.168.0.1): 56 data bytes
ping: sendto: Network is unreachable
# ifconfig
lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

# ifconfig eth0 192.168.0.2 up
eth0: XLlTemac: Options: 0x3fa
eth0: XLlTemac: allocating interrupt 1 for dma mode tx.
eth0: XLlTemac: allocating interrupt 2 for dma mode rx.
eth0: XLlTemac: speed set to 100Mb/s
eth0: XLlTemac: Send Threshold = 24, Receive Threshold = 4
eth0: XLlTemac: Send Wait bound = 254, Receive Wait bound = 254
# ping 192.168.0.1
PING 192.168.0.1 (192.168.0.1): 56 data bytes
64 bytes from 192.168.0.1: seq=0 ttl=64 time=19.574 ms
64 bytes from 192.168.0.1: seq=1 ttl=64 time=8.747 ms

--- 192.168.0.1 ping statistics ---
2 packets transmitted, 2 packets received, 0% packet loss
round-trip min/avg/max = 8.747/14.160/19.574 ms
# 
# 
# 
# ping 192.168.0.1
PING 192.168.0.1 (192.168.0.1): 56 data bytes
64 bytes from 192.168.0.1: seq=0 ttl=64 time=20.466 ms
64 bytes from 192.168.0.1: seq=1 ttl=64 time=8.598 ms
64 bytes from 192.168.0.1: seq=2 ttl=64 time=8.608 ms
64 bytes from 192.168.0.1: seq=3 ttl=64 time=8.603 ms

--- 192.168.0.1 ping statistics ---
4 packets transmitted, 4 packets received, 0% packet loss
round-trip min/avg/max = 8.598/11.568/20.466 ms
#
 
fdt/fdt/logs/2.6.30-rc7-mmu-initramfs.txt · Last modified: 2009/07/01 16:10 (external edit)
 
Except where otherwise noted, content on this wiki is licensed under the following license:CC Attribution-Noncommercial-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki