SDRAM :
                Icache:OK
                Dcache:OK
        U-Boot Start:0x9ffc0000
FLASH: 32 MB
MAC:00:E0:0C:00:00:FD
eth0: Xilinx XPS LocalLink Tri-Mode Ether MAC #0 at 0x81C00000.
Unsupported mode
*** Warning - bad CRC, using default environment

U-BOOT for Xilinx-ML505-ll_temac-sgdma-MMU-FDT-edk101

U-Boot-mONStR> run ml505
TFTP from server 192.168.0.102; our IP address is 192.168.0.3
Filename 'image.ub'.
Load address: 0x90800000
Loading: 100BASE-T/FD
#################################################################
         #################################################################
         ##########################################################
done
Bytes transferred = 2752580 (2a0044 hex)
TFTP from server 192.168.0.102; our IP address is 192.168.0.3
Filename 'system.dtb'.
Load address: 0x90780000
Loading: 100BASE-T/FD
#
done
Bytes transferred = 9101 (238d hex)
TFTP from server 192.168.0.102; our IP address is 192.168.0.3
Filename 'romfs.ub'.
Load address: 0x90c80000
Loading: 100BASE-T/FD
#################################################################
         ############################################################
done
Bytes transferred = 1827904 (1be440 hex)
## Booting kernel from Legacy Image at 90800000 ...
   Image Name:   kernel bez FS
   Image Type:   MicroBlaze Linux Kernel Image (uncompressed)
   Data Size:    2752516 Bytes =  2.6 MB
   Load Address: 90000000
   Entry Point:  90000000
   Verifying Checksum ... OK
## Loading init Ramdisk from Legacy Image at 90c80000 ...
   Image Name:   fs v no network
   Image Type:   MicroBlaze Linux RAMDisk Image (uncompressed)
   Data Size:    1827840 Bytes =  1.7 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK
OK
## Flattened Device Tree blob at 90780000
   Booting using the fdt blob at 0x90780000
## Loading init Ramdisk from Legacy Image at 90c80000 ...
   Image Name:   fs v no network
   Image Type:   MicroBlaze Linux RAMDisk Image (uncompressed)
   Data Size:    1827840 Bytes =  1.7 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
## Transferring control to Linux (at address 90000000), 0x00000000 ramdisk 0x90c80040, FDT 0x90780000...
early_printk_console is enabled at 0x84000000
Ramdisk addr 0x90c80040, FDT 0x90780000
Found romfs @ 0x90c80040 (0x001bf000)
#### klimit 902f5000 ####
Moving 0x001bf000 bytes from 0x90c80040 to 0x902f42b8
New klimit: 0x904b4000
Found FDT at 0x90780000
Linux version 2.6.29-rc8-00471-g1c49229-dirty (monstr@monstr.eu) (gcc version 3.4.1 ( PetaLinux 0.20 Build -rc1 050607 )) #9 Thu Mar 19 10:32:42 CET 2009
setup_cpuinfo: initialising
setup_cpuinfo: Using full CPU PVR support
setup_memory: Main mem: 0x90000000-0xa0000000, size 0x10000000
setup_memory: kernel addr=0x90000000-0x904b4000 size=0x004b4000
setup_memory: max_mapnr: 0x10000
setup_memory: min_low_pfn: 0x90000
setup_memory: max_low_pfn: 0xa0000
On node 0 totalpages: 65536
free_area_init_node: node 0, pgdat 902842f0, node_mem_map 904b4000
  Normal zone: 512 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 65024 pages, LIFO batch:15
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 65024
Kernel command line: console=ttyUL0,115200 highres=on
xlnx,xps-intc-1.00.a #0 at 0x81800000, num_irq=9, edge=0x100
PID hash table entries: 1024 (order: 10, 4096 bytes)
xlnx,xps-timer-1.00.a #0 at 0x83c00000, irq=3
Heartbeat GPIO at 0x81400000
microblaze_timer_set_mode: shutdown
microblaze_timer_set_mode: periodic
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 254848k/262144k available
ODEBUG: selftest passed
Calibrating delay loop... 61.64 BogoMIPS (lpj=308224)
Mount-cache hash table entries: 512
net_namespace: 544 bytes
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
NET: Registered protocol family 1
msgmni has been set to 498
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
84000000.serial: ttyUL0 at MMIO 0x84000003 (irq = 8) is a uartlite
console [ttyUL0] enabled
brd: module loaded
nbd: registered device at major 43
uclinux[mtd]: RAM probe address=0x902f42b8 size=0x1bf000
Creating 1 MTD partitions on "RAM":
0x000000000000-0x0000001bf000 : "ROMfs"
uclinux[mtd]: set ROMfs to be root filesystem index=0
TCP cubic registered
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
VFS: Mounted root (romfs filesystem) readonly on device 31:0.
Freeing unused kernel memory: 96k freed
Mounting proc: 
Mounting var: 
Populating /var: 
Running local start scripts.
Mounting /etc/config: 
Populating /etc/config: 
flatfsd: Nonexistent or bad flatfs (-48), creating new one...
flatfsd: Failed to write flatfs (-48): No such device
flatfsd: Created 6 configuration files (310 bytes)
Mounting sysfs:
Setting hostname: 
Setting up interface lo: 
Setting up interface eth0: 
SIOCSIFADDR: No such device
Starting thttpd: 

uclinux login: 
 
fdt/fdt/logs/2.6.29-rc8-nommu.txt · Last modified: 2009/07/01 16:10 (external edit)
 
Except where otherwise noted, content on this wiki is licensed under the following license:CC Attribution-Noncommercial-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki